 |
|
Mount the Transducer Wave-Guide Tube parallel to the forks. Zip tie the Transducer Cable securely to the Transducer Head. Adjust the Tubes to avoid damage from hard bottoming and full extension.
Follow these instructions carefully or damage to the Wave-Guide tubes may result. When you have completed this section go to 3.4 Adjusting the Tubes.
Note: Do not plug the end of the inner tube it is an air vent.
> Upper Forks Generally the easiest way to mount the top clamp is to zip tie it to the fork or handlebar. Use a bit of foam tape between the clamp and the tube to help keep it from moving up and down. It is OK to have a bit of side movement. Crisscrossing the zip ties is often helpful.
> Lower Forks Generally the easiest way to mount the bottom clamp is to zip tie it to the fork. Use a bit of foam tape between the clamp and the tube to help keep it from moving up and down. It is OK to have a bit of side movement. Crisscrossing the zip ties is often helpful. (Sounds a lot like the instructions for the top mount doesn't it?.)
Connect the ShockClock to the Transducer. Zip tie any extra cable.
To finish Front Mounting go to 3.4 Adjusting the Tubes. |
