 |
|
When you have completed this section go to 3.4 Adjusting the Tubes. The completed mounting is typically on the left fork leg using the “Looped” Control Rod. The top of the Transducer will be below the bottom triple clamp. Check the clearance with the radiator when the forks are turned to the stops.
> Fork Upper Mount – USD – RR Use the “Looped” Control Rod and loosely hose clamp it to the fork tube. Position it so it is out of the way and has clearance during fork travel use.
> Fork Lower Mount – USD – RR Replace the inner axle pinch bolt with a longer one and torque it normally. Put the Looped end of the control rod on, add a washer, and a Nylock nut. Bend the control rod so everything lines up without a side load. Make sure there is more travel in the Transducer than the fork has and it has clearance when the fork is fully extended (including the top-out spring. Tighten the hose clamp.
|
